The common construction problems of car film wrap?

What are the common construction problems of car film wrap?

Car film is a very technical car beauty project. If you are not careful, it is very likely to cause various construction errors or defects, particles, dust spots, wrinkles, uneven edges, etc. due to the environment, construction personnel, tools and other reasons.

So, what are the common problems of car film wrap, what are the reasons, and what methods can be solved?

The most common problems of car film sharing are as follows. The causes and solutions are as follows:

one. bubble

① Phenomenon: After the car film wrap is drained, there are still  bubbles, which do not match the glass;

② Reason: There are two main reasons for this phenomenon:

incomplete drainage;

Poor molding of automobile film. When it does not conform to the shape of the window, it is eager to install it.

two. Folds

① Phenomenon: The car film is wrinkled and stuck together inside, which cannot be eliminated after being flattened;

② Reason: There are three main reasons for this phenomenon

excessive forming, burnt car film;

The drainage method is incorrect when the film is applied, and the car wrap film is pleated;

accidentally peeling off the protective film or car window film, causing the car film to fold;

three. Uneven edges

① Phenomenon: The distance between the edge of the window film and the edge of the glass is not equal, which is jagged or wavy;

② Reason: There are two main reasons for the formation

The drainage tool is not polished, flat, and has sharp protrusions;

The glass is not cleaned, there are sundries such as sand, and the tool scratches the window film when the drainage is not careful;

Four. Unrepaired fillet

① Phenomenon: The corners of the window film are not changed into an arc shape, and the glass is easy to roll up when it is raised and lowered.

② Cause: Carelessly when cutting the film;

five. Car film scratches

① Phenomenon: When the window film is drained, holes are hung out, that is to say, the window film is scratched.

② Cause

The drainage tool is not polished, flat, and has sharp protrusions;

The glass is not cleaned, there are sundries such as sand, and the tool scratches the window film when the drainage is not careful;

six. Including debris

① Phenomenon: There is foreign matter between the window film and the glass, such as dust, sand, dirt, etc.

② Reasons for formation:

working environment;

used film products;

the construction unit’s own reasons;

Leave a Reply

Your email address will not be published.

You cannot copy content of this page